Welding of eyelets
1. preparation
Before welding eyelets, it is important to close the joint as tightly as possible.
This means that the wire ends must touch each other.
If possible, press the eyelet together lightly, e.g. with the crocodile clip or pliers.
2. welding of thin eyelets
With chains, the clamp should always make contact with the eyelet that is being welded.
Depending on the thickness of the eyelet, you should start with a small capacity and then carefully increase it if necessary.
For thin eyelets, a spot weld directly from above is usually sufficient.
2. welding of thick eyelets
You should not necessarily increase the welding power for thicker eyelets.
It is better to weld from both sides with low to medium power.
Depending on the wire thickness, more welding points may be required on all sides.
